Harmonic Active Filter Using Multiplication Sine Function Method to Reduce Current Distortion

Authors

  • Irianto Electrical Engineering Department, Electronics Engineering Polytechnic Institute of Surabaya, Surabaya, Indonesia
  • Ahmad Firyal Adila Electrical Engineering Department, Electronics Engineering Polytechnic Institute of Surabaya, Surabaya, Indonesia
  • Farid Dwi Murdianto Electrical Engineering Department, Electronics Engineering Polytechnic Institute of Surabaya, Surabaya, Indonesia
  • Muhammad Azumardi Fahmi Electrical Engineering Department, Electronics Engineering Polytechnic Institute of Surabaya, Surabaya, Indonesia
Volume: 15 | Issue: 5 | Pages: 26249-26255 | October 2025 | https://doi.org/10.48084/etasr.11141

Abstract

The use of Variable Frequency Drives (VFDs) is unavoidable, especially in the industrial sector, where motor speed regulation is required to expedite production. VFDs are included in nonlinear loads, which, when in use, can cause the voltage and current of the source to differ. When a source carries a nonlinear load, the current distorts, resulting in a non-sinusoidal shape. The degree of distortion, Total Harmonic Distortion (THD), shows that as THD increases, the signal becomes more distorted. To reduce the distorted source currents, active harmonic filters are used and arranged in parallel between the source and the load. The active harmonic filter works by producing a harmonic current that eliminates the distorted source current, which is achieved by extracting the current distortion signal using the multiplication-with-sine-function method. When the mesh source is loaded with a VFD, the THD of the source current is 45.35%. According to the 2014 IEEE-519 standard, the maximum THD value of the current should be 5%, which is not met, so an active harmonic filter is installed. After installing the active harmonic filter, the THD of the current dropped to 3.57%. This was achieved with a VDC setpoint of 500 V, stabilized by Proportional Integral (PI) control with a P value of 17.543 and I value of 0.00018.

Keywords:

harmonics, non linear load, power quality, Total Harmonic Distortion (THD), multiplication with sine function, PI controller

Downloads

Download data is not yet available.

References

A. Priyadharshini, N. Devarajan, A. R. Uma Saranya, and R. Anitt, "Survey of Harmonics in Non Linear Loads," International Journal of Recent Technology and Engineering (IJRTE), vol. 1, no. 1, pp. 92–96, Apr. 2012.

S. K. Sheikh, M. Jain, and P. C. Tapre, "Enriched I-Q Active Filter Based Harmonics Mitigation in Rectifier-Inverter Fed Induction Motor Drive," Tehnicki glasnik, vol. 19, no. 2, pp. 181–191, Jun. 2025.

J. Arrillaga and N. R. Watson, Power System Harmonics. Hoboken, NJ, USA: Wiley, 2003.

519-2014 -IEEE Recommended Practice and Requirements for Harmonic Control in Electric Power Systems. New York, NY, USA: IEEE, 2014.

A. H. Ukande, S. L. Tiwari, and S. G. Kadwane, "Noval approach to single phase shunt active filter with SPWM switching strategy," in 2015 International Conference on Industrial Instrumentation and Control (ICIC), Pune, India, Feb. 2015, pp. 1268–1272.

G. Son, H.-J. Kim, and B.-H. Cho, "Improved Modulated Carrier Control With On-Time Doubler for a Single-Phase Shunt Active Power Filter," IEEE Transactions on Power Electronics, vol. 33, no. 2, pp. 1715–1723, Oct. 2018.

J. Afonso, M. Aredes, E. Watanabe, and J. Martins, "Shunt Active Filter for Power Quality Improvement," in International Conference UIE 2000 – Electricity for a Sustainable Urban Development, Lisboa, Portugal, Nov. 2000.

F. Aiwa, M. T. Alkhayyat, and M. Y. Suliman, "A Review on PQ Theory Based Shunt Active Power Filter," Design Engineering, no. 6, pp. 6919–6938, Sep. 2021.

H. Akagi, "Modern active filters and traditional passive filters," Bulletin of the Polish Academy of Sciences. Technical Sciences, vol. 54, no. 3, pp. 255–269, 2006.

P. S. Magdum and U. T. Patil, "Development of single phase shunt active power filter," in 2017 International Conference on Inventive Communication and Computational Technologies (ICICCT), Coimbatore, India, Mar. 2017, pp. 351–355.

T. Demirdelen, R. I. Kayaalp, and M. Tumay, "A Modular Cascaded Multilevel Inverter Based Shunt Hybrid Active Power Filter for Selective Harmonic and Reactive Power Compensation Under Distorted/Unbalanced Grid Voltage Conditions," Engineering, Technology & Applied Science Research, vol. 6, no. 5, pp. 1133–1138, Oct. 2016.

H. Dogan and R. Akkaya, "A Simple Control Scheme for Single-Phase Shunt Active Power Filter with Fuzzy Logic Based DC Bus Voltage Controller," in International MultiConference of Engineers and Computer Scientists, Hong Kong, China, Mar. 2009.

P. K. Joshi and S. S. Bohra, "Simulation of single phase Shunt Active Power Filter for domestic non-linear loads," in 2013 IEEE 8th Conference on Industrial Electronics and Applications (ICIEA), Melbourne, VIC, Australia, Jun. 2013, pp. 43–48.

M. A. A. M. Zainuri, M. A. M. Radzi, A. C. Soh, N. Mariun, and N. Abd. Rahim, "DC-link capacitor voltage control for single-phase shunt active power filter with step size error cancellation in self-charging algorithm," IET Power Electronics, vol. 9, no. 2, pp. 323–335, Feb. 2016.

S. Saswat, "Study of Single Phase Shunt Active Power Filter," B. Thesis, Department of Electrical Engineering, National Institute of Technology, Rourkela, Odisha, India, 2014.

N. Mohan, T. M. Undeland, and W. P. Robbins, Power Electronics: Converters, Applications, and Design, 3rd ed. Hoboken, NJ, USA: Wiley, 2003.

R. K. Pandey, V. Purwar, and N. Sharma, "Hysteresis Current Control Based Shunt Active Power Filter for Six Pulse Ac/Dc Converter," International Journal of Engineering Research and Applications, vol. 07, no. 02, pp. 26–30, 2017.

E. M. Suhara and M. Nandakumar, "Analysis of hysteresis current control techniques for three phase PWM rectifiers," in 2015 IEEE International Conference on Signal Processing, Informatics, Communication and Energy Systems (SPICES), Kozhikode, India, Oct. 2015, pp. 1–5.

P. Rathika and D. Devaraj, "Fuzzy Logic – Based Approach for Adaptive Hysteresis Band and Dc Voltage Control in Shunt Active Filter," International Journal of Computer and Electrical Engineering, vol. 2, no. 3, pp. 404–412, Jun. 2010.

A. A. Imam, R. Sreerama Kumar, and Y. A. Al-Turki, "Modeling and Simulation of a PI Controlled Shunt Active Power Filter for Power Quality Enhancement Based on P-Q Theory," Electronics, vol. 9, no. 4, p. 637, Apr. 2020.

Y. Tang, P. C. Loh, P. Wang, F. H. Choo, F. Gao, and F. Blaabjerg, "Generalized Design of High Performance Shunt Active Power Filter With Output LCL Filter," IEEE Transactions on Industrial Electronics, vol. 59, no. 3, pp. 1443–1452, Mar. 2012.

Downloads

How to Cite

[1]
. Irianto, A. F. Adila, F. D. Murdianto, and M. A. Fahmi, “Harmonic Active Filter Using Multiplication Sine Function Method to Reduce Current Distortion”, Eng. Technol. Appl. Sci. Res., vol. 15, no. 5, pp. 26249–26255, Oct. 2025.

Metrics

Abstract Views: 6
PDF Downloads: 2

Metrics Information